Maintenance and sharing of granule packing machine
We are a big printing company in Shenzhen China . We offer all book publications, hardcover book printing, papercover book printing, hardcover notebook, sprial book printing, saddle stiching book printing, booklet printing,packaging box, calendars, all kinds of PVC, product brochures, notes, Children's book, stickers, all kinds of special paper color printing products, game cardand so on.
For more information please visit
http://www.joyful-printing.com. ENG only
http://www.joyful-printing.net
http://www.joyful-printing.org
email: info@joyful-printing.net
Maintenance of the granule packing machine is essential for long-term use.
Mechanical lubrication
1. The tank part of the machine is equipped with oil meter. It should be refueled once before driving. It can be added according to the temperature rise and operation of each bearing.
2. The worm gear box must store oil for a long time. The height of the oil surface is all invaded into the oil. If it is used frequently, it should be replaced with new oil every three months. There is oil plug at the bottom of the sputum.
3. When the machine is refueling, do not let the oil spill out of the cup, and do not flow to the surroundings of the machine and the ground. Because oil is easy to contaminate materials, affecting product quality.
Care instructions
1. Check the machine regularly and check it once a month to check whether the worm gear, the worm, the bolts on the lubrication block, the bearing and other moving parts are flexible and wearable. The defects should be repaired in time and should not be used barely.
2. The machine should be used in a dry and clean room. It should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then installed, ready for the next use.
4. When the drum moves before and after the work, please adjust the M10 screw of the front bearing to the appropriate position. If the shaft is turbulent, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make a sound, and turn the pulley by hand. It is appropriate to loosen tightly. If it is too tight or too loose, the machine may be damaged.